Moseley 221 - Center for Race, Ethnicity, and Diversity Education

Tags moseley crede

Room Summary

 

 

 

Located on the second floor of Moseley, this room serves as the Center for Race, Ethnicity, and Diversity Education (CREDE) for Elon University students. CREDE is not only a physical space located on the second floor of Moseley, but is also the center of support for our ALANAM (African American/Black, Latino/Hispanic, Asian/Pacific Islander, Native American, Alaskan Native and Multiracial) communities and the convener of student diversity education campus-wide.

For more information about Elon University's Center for Race, Ethnicity, and Diversity Education, visit the CREDE home page .

Available Technology

Below is a list of all the technology available in Moseley 221.

Equipment Manufacturer  Model/Type 
Control Panel  Crestron  MPC-M10
Flat Panel Display  Sharp  LC-70LE650U

 

1.) Control Panel (Crestron)

A picture of the Crestron control panel. 

  1. To turn the system on, press the ON button in the top left corner of the control panel.
  2. Use the Extron wall plate (displayed above) to input your device.
  3. Select input on the Creston control panel (HDMI, VGA, TV, Air Media).
  4. To control volume, turn the knob on the right side of the control panel.
  5. To turn off the system, press and hold the OFF button, which is located directly to the right of the ON button.

 

2.) TV (Sharp)

 

Basic Operating Instructions

  1. To turn on the TV, press the ON button in the top left corner of the control panel.
  2. To adjust the volume,turn the knob on the right side of the control panel.
  3. To change the channel, press the up and down channel arrows on the control panel.
  4. To turn off the TV, press and hold the OFF button, which is located directly to the right of the ON button.

HDMI/VGA Instructions

  1. Press the HDMI or VGA button on the control panel.
  2. Use the HDMI or VGA and VGA audio cable, located in the cabinets below the TV, to plug your personal device into the wall plate right below the TV.  
  3. Ensure your device is on.

AirMedia Instructions

  1. Press the AirMedia button on the control panel.
  2. A screen similar to the one shown below will appear on the screen.
  3. Type the IP address URL displayed at the bottom of the screen into a browser on your personal device.
  4. If you have not used AirMedia before you will have to download the AirMedia software. Follow the instructions on the website.
  5. Once the software opens, it will prompt you for a room code. This is a four digit code found at the bottom of the projector screen, beneath the URL.
  6. Click on the "Connect" button, and your device's screen will appear on the projected screen.
  7. To stop presenting, click on the disconnect button.
Print Article